DESCRIPTION
Please Note, this is a do-it-yourself kit with fully soldered electronics - you must assembled the parts yourself. The DIY Digital Oscilloscope Kit uses an ARM Cortex-M3 processor and with 2.4-inch screen. It can display waveform parameters, such as frequency, period, pulse width, duty ratio, MAX./MIN./AVG./Peak-Peak/virtual values.

FEATURES
- Auto/Normal/Single trigger modes to easily capture current waveforms
- Has rising or falling edge trigger
- Observable previous waveform before trigger (negative delay)
- Can save waveform display at any time with the HOLD function
- Waveform Storage Function: Will not lose the waveform after powering off
- Short-circuit and Open-Circuit Detection: Can help find soldering errors
- Number of Channels: 1
- Analog Bandwidth: DC 200kHz
- Sensitivity: 5mV/div to 20V/div in 1-2-5 steps
- Sensitivity Accuracy: 5%
- Input Impedance: 1MΩ
- Maximum Input Voltage: 100V peak-to-peak
- Coupling: DC, AC, GND - Resolution: 12 bit
- Real-Time Sampling Rate: 1Ms/s max.
- Time Base: 10μs/div to 500s/div in 1-2-5 steps
- Memory Size: 1,024 samples
- Trigger Modes: Auto, Normal, Single
- Trigger Type: increasing/decreasing flank
- Trigger Position: in half of the memory
- Display Type: 2.4 inch color TFT-LCD
- Display Resolution: 320 x 240 pixels
- Supply Voltage: 9.0 Vdc
- Supply Current: 120 mA typical
- Dimensions: 115 x 75 x 22mm