LED Turn Signal Flash Rate Controllers Load Resistors

A pair of LED Turn Signal Controller Load Resistors. LED load resistors can be used when replacing all or only some of the existing bulbs with LED's, due to LED's drawing less power this can trigger the indicators to rapid flashing which this controller is specified for.

- Install or repair your turn signal controllers on your bike, motorcycle, ATV
- Turn your LED strips in turn signals with the Load Resistors
- Each LED Turn Signals requires one resistor
- Material: Copper Heat Sink (reduces heat)
- 25W; 8 ohms
- Wire length: 12 inches (Approx.)
- Dimensions: 1.1" x 0.6" x 0.6"